440V Shot Blasting Dust Collector,
380V Shot Blasting Dust Collector,
440V sandblaster dust extractor
Shot blasting dust collector air cleaning for different shot blasting machines
This machine adopts advanced three-stage flow curtain full curtain broken projectiles separator. Adopting the German AGTOS modular structure, the performance is more excellent, and the maintenance cost is reduced by 60%. The separation efficiency of the projectiles of the separator is increased to ≥99.9%, and the qualified pellets contain impurities such as sand ≤0.1%.
The projectiles sorted by the separator second stage sorting flow into the small storage hopper below, and it is judged whether it can continue to be used manually. If it meets the requirements for use, it will flow into the circulation system for continued use, otherwise, it will flow into the waste bin and be treated as waste.
The storage bin at the lower part of the separator is equipped with a minimum material level detection. When the projectiles in the storage bin are lower than the projectile volume required for normal use of the equipment, the level gauge sends a signal to the PLC system, and the PLC sends a notification of adding projectiles on the touch screen in time. Prevent the impact of the shot blasting effect due to the lack projectile of circulatory system.
The screw conveyor is composed of a cycloidal pinwheel reducer, a screw shaft, a bearing with a seat, etc. It is a standard horizontal conveying equipment for shot sand and an important part of the shot blasting machine's shot circulation system.
The screw conveyor is a serialized part of our company, with high versatility and interchangeability, stable and reliable performance. The entire spiral shaft is processed after welding to ensure coaxiality.
The screw conveyor blade is made of 16Mn high-strength manganese steel, which is stretched at one time, and is processed as a whole, with high strength, long life, good precision, strict process and high interchangeability.
This projectile controller is a special blasting gate for the hook rotary type shot blasting machine of our company. Because this machine has a fast production cycle, it is very important to control the speed of the blast wheel, so the two abrasive supply gates are controlled by one cylinder, Open or close at the same time, so that it is convenient to control the two shot blasting machines, the two shot blasting machines stop at the same time, the beat is compact, and the operation lag will not occur.
In view of the problem of damage to the bearings at both ends that often occurred in the past equipment, the analysis is mainly due to the lack of sealing of the bearings at both ends, and the particulate matter or iron dust enters the bearing through the end plate, causing damage to the bearing. Based on many years of practical experience on site, our company adopts tapered reverse counterflow + compound labyrinth + terminal overflow + J-seal multiple active sealing technology to ensure the bearing is not affected by any projectiles.
The abrasive control unit is the abrasive flow control mechanism of the blast wheel, and the opening and closing angles of the unit can be controlled electrically or pneumatically. The sand flow rate is displayed on the instrument of the electrical system.
Contact Person: Amber
Tel: 0086 13656393699